LawnMaster CLMF4841E - Troubleshooting

29
TROUBLESHOOTING
PROBLEM POSSIBLE CAUSE SOLUTION
Mower fails to start.
The isolator key is not installed
correctly/fully.
Install the isolator key correctly.
The batteries are not installed
correctly.
Ensure the batteries are
correctly installed.
The batteries are not fully
charged.
Charge the batteries.
Possible clogging.
Remove the isolator key and
batteries. Check underneath the
mower and clear as necessary
(always wear gardening
gloves).
The grass is too long. Set a higher cutting height.
The batteries are defective. Replace the batteries.
Defective switch lever or safety
button.
Repair by a qualied person.
The motor stops.
The mower is blocked by
foreign object.
Remove the foreign object.
Motor protection has engaged
due to overheating.
Allow the mower to cool down.
Cut long grass down in stages
and avoid overloading the
motor.
The mower cuts grass unevenly
or motor labours.
The lawn is rough or uneven or
cutting height not set properly.
Adjust the cutting position to the
height best suited for your lawn.
The blade is blunt. Replace the blade.
The blade area is blocked.
Clean the blade area and
remove the blockage.
The blade is assembled
incorrectly.
Install the blade correctly. Blade
wings should be facing up away
from the ground.
Only perform the steps described within these instructions! All further inspection, maintenance and
repair work must be performed by a qualied specialist.
Gloves and appropriate protective clothing must be worn when performing these instructions.
Always turn off the machine and remove the battery pack and isolator key before making any
adjustment.
WARNING