27
MAINTENANCE
To replace the blades
■ Press the STOP button and allow the blade to come to a complete stop.
■ Lift the battery compartment cover. Remove the isolator key and the battery.
■ Slowly turn the mower over. Place it on a soft and clean surface.
■ Use a suitable tool (e.g., a screwdriver) to insert into one of three holes in the blade disc to x it
in place (Fig. 19). This ensures the blade disc is not turning when replacing the blades to avoid
personal injury.
■ Wear protective gloves and use a screwdriver or hexagonal socket wrench to remove all three
screws and blades (Fig. 20).
■ Secure the new blades with new screws.
■ Make sure all blades can spin freely.
Cleaning the Underside
It is recommended to check and clean the underside of the robotic mower regularly.
■ Press the STOP button and allow the blade to come to a complete stop.
■ Lift the battery compartment cover. Remove the isolator key and the battery.
■ Slowly turn the mower over. Place it on a soft and clean surface.
■ Use a soft brush or damp cloth to remove dirt, dust, oil, grease, etc. from the underside of the
mower.
IMPORTANT: Do not wash the mower with running water.
■ Wear safety gloves to clean the blade disc, the chassis, and the front and rear wheels
thoroughly with a soft brush or damp cloth. Remove any lodged debris around them.
■ Make sure the blade disc can rotate freely and all blades can spin freely.
Storing the Mower (See Fig. 21)
It is recommended to store the mower indoors between uses.
■ Before storing your mower, remove the isolator key and the battery pack.
■ Clean the mower thoroughly.
■ Use the carry handle to carry the mower. Carry the mower with the blade disc away from the
body (Fig. 21).
■ Store the mower indoors in a clean, dry place out of the reach of children.
IMPORTANT: Protect the underside of mower from standing water. NEVER store the mower
upside down outdoors.
Battery and Charger Maintenance
■ Keep the battery and charger clean and clear of debris. Do not allow foreign material into the
recessed cavity or on the contacts. Wipe with a dry cloth. Do not use solvents, water, or place in
wet conditions.
■ Always unplug the charger when there is no battery pack in it.
■ Check that the charger and battery contacts have not been shorted by debris or foreign material.
To Next Page
Loading...
