OPERATION
Cutting device - advancing the trimmer line (Figs. 6)
In order to advance a length of trimmer line, firmly tap the bump cap on the lawn while the trimmer
is running. This will automatically advance a new length of trimmer line and trim the line to the
correct length. A firm but gentle motion should be used when tapping the bump cap on the lawn.
This advancing process may be repeated as often as necessary. Never try to advance the line on
a hard surface such as a sidewalk or driveway. If unit fails to advance, unplug power from trimmer
and clean the bump cap both inside and out.
Flower Guard
Pull the flower guard out of the trimmer head (Fig.7). If the flower guard is no longer required, it can be
pushed in again (park position).
Using the flower guard
The grass trimmer is equipped with a flower guard that can be lowered to push flowers away from
the cutting line so they are protected (Fig.8). The flower guard is an indicator of the maximum
cutting range of the line.
Fig. 7
Fig. 8
12
Fig. 6
To Next Page
Loading...
