13
Trimming
1. Hold the tool as shown. what figure are you referencing.(Fig.9)
2. Gently swing the trimmer from side to side .(Fig. 10)
3. When cutting long grass, work in stages from the top. Take small cuts. Keep the tool away from
hard objects and delicate plants.
4. If the tool starts running slowly, reduce the load.
• Do not cut moist or wet grass.
• Before starting the trimmer check that the cutting head will not come into contact with stones,
rubble or other foreign bodies.
• Switch on the trimmer before you approach the grass that is to be cut.
• Always trail the extension cord behind you. Do not pass the operating trimmer over the extension
cord as the cord could be damaged.
• Do not overload the trimmer during operation.
• Avoid contact with obstacles (stones, walls, fences, etc.) as this will rapidly wear out the trimmer line.
• Do not hit the cutting head on the ground during operation.
• Ensure that the cutting head has stopped before you deposit the equipment on the ground. Cut
the grass by swaying the trimmer sideways to the right and left. Cut slowly, keeping the grass
trimmer inclined forward slightly when cutting. Cut tall grass by a series of levels from top to bottom.
OPERATION
Fig. 9 Fig. 10
WARNING
Danger of injury!
WARNING Never attempt to lock the trigger lever in the on position.
To Next Page
Loading...
Need help?
General
