LawnMaster L10 - Wiring a Sub Zone; Connect and Install the Base Station

17
ASSEMBLY
In the case that two islands are too close, the width between two islands no more than 1m, it is
recommended to lay out the boundary wire as illustrated (Fig. 15).
How to wire a sub zone
,IWKHUHDUHDGGLWLRQDO]RQHVLQ\RXUODZQ
Ŷ7RDOORZWKHPRZHUWRGULYHWKURXJKWKHQDUURZSDVVDJHVPRRWKO\WKHQDUURZSDVVDJHWKDW
FRQQHFWVWKHPDLQ]RQHDQGVXE]RQHVKRXOGEHDWOHDVWPZLGHDQGDWPRVWPORQJ)LJ
16).
Ŷ0DNHVXUHWKHQDUURZSDVVDJHLV¿UPOHYHODQGVPRRWK
Ŷ,IWKHQDUURZSDVVDJHWKDWFRQQHFWVWZRDUHDVLVWRRQDUURZIRUWKHURERWLFODZQPRZHUWR
QDYLJDWHOD\WKHERXQGDU\ZLUHDURXQGWKHVXE]RQHVRWKDWLWIRUPVDQLVODQGRXWVLGHRIWKH
PDLQ]RQH)LJ&DUU\WKHPRZHUPDQXDOO\WRWKHVXE]RQH7KHPRZHUZLOOPRZXQWLOWKH
EDWWHU\UXQVRXW7KHQWDNHWKHPRZHUEDFNWRWKHEDVHVWDWLRQLQWKHPDLQ]RQHIRUUHFKDUJH
Connect and Install the Base Station (See Figs. 18-22)
NOTE: Start at the base station’s location to lay the boundary wire anti-clockwise around the lawn.
NOTE: The boundary wire must be laid and connected to the base station before securing the
base station to the ground.
Ŷ3ODFHWKHEDVHVWDWLRQRQWKHJURXQGLQWKHGHVLUHGSRVLWLRQ)ROORZWKHLQVWUXFWLRQVLQWKH³6HOHFW
WKH3URSHU%DVH6WDWLRQ/RFDWLRQ´VHFWLRQ'RQRWFRQQHFWWKHEDVHVWDWLRQWRWKHPDLQVRU¿[
into place.
Ŷ3HJWKHVWDUWLQJHQGRIWKHERXQGDU\ZLUHLQWRSODFHDWSRVLWLRQDVLOOXVWUDWHGFORVHWRWKH
terminals at the rear of the base station), leaving 20cm length for connection later (Fig. 18).
Ŷ,QVWDOOWKHERXQGDU\ZLUHDQWLFORFNZLVHDURXQGWKHODZQDVGHVFULEHGLQWKH³/D\WKH%RXQGDU\
:LUH´VHFWLRQ
Ŷ5XQWKHHQGRIWKHERXQGDU\ZLUHWKURXJKWKHVORWXQGHUWKHEDVHVWDWLRQOHDYLQJFP
length for connection later (Fig. 18).
Ŷ:LWKWKHZLUHVWULSSHUSURYLGHGVWULSPPRILQVXODWLRQPDWHULDOIURPWKHHQGVRIWKH
boundary wire for connection to the base station (Fig. 19).
Ŷ%HIRUHFRQQHFWLQJWKHERXQGDU\ZLUHWRWKHEDVHVWDWLRQHQVXUHWKHEDVHVWDWLRQSRZHUVXSSO\
is disconnected from the mains.
Ŷ,QVHUWWKHZLUHHQGVLQWRWHUPLQDOVDWWKHUHDURIWKHEDVHVWDWLRQ5XQWKHVWDUWLQJZLUH
through the hook (C) of the base station and connect it to the red terminal (A). The end of the
wire ( ) that runs under the base station connects to the black terminal (B). To insert the wire
end into the terminal, press down on the tab of the terminal until the terminal hole is visible, fully
insert the wire end into the corresponding terminal, and then release the tab to secure the wire
HQG*HQWO\SXOOWKHZLUHVRQFHWKH\DUHFRQQHFWHGDQGPDNHVXUHWKH\DUHFRQQHFWHG¿UPO\
into place. This is important to ensure correct signal of the boundary wire (Fig. 20).
1
1
2
2