LawnMaster NPTGSP2617A - Other Troubleshooting Issues

38
NOPULL
TM
STARTER SYSTEM
male and female terminals in the corrugated pipe buckle;
3). The stop switch has broken.
B. Test the stop switch wiring harness of the engine (Fig. 82). If conduction fails, the possible causes
are:
1). An open circuit in the connection position between the wiring harness of the engine and the
ignition coil;
2). An open circuit in the connection position between the wiring harness of the engine part and
the engine cover;
3). There is loose or failed contact in the connection between the wiring harness of the engine and
the bullet terminals.
Fig. 82
Fig. 81