LawnMaster NPTGSP2617A - Trimming Tips and Line Advancement

26
OPERATION
Fig. 29
A - Direction-of-rotation
B - Dangerous cutting area
C - Best cutting area
B
C
A
TRIMMING TIPS (See Figs. 28-29)
Ŷ.HHSWKHWRROWRWKHULJKWVLGHDQGDZD\IURP\RXUERG\WRDYRLGPDNLQJFRQWDFWZLWKWKHKRW
surfaces (Fig. 28).
Ŷ.HHSWKHWULPPHUKHDGORZHUHGWRZDUGVWKHDUHDEHLQJFXW
Ŷ7KHVWUDLJKWVKDIWWULPPHUFXWVEHVWZKHQPRYLQJWKHXQLWIURPOHIWWRULJKW3DVVLQJWKHWRROLQ
this direction will reduce the amount of debris thrown towards the operator. Avoid cutting in the
dangerous area as shown (Fig. 29).
Ŷ8VHWKHWLSRIOLQHWRGRWKHFXWWLQJGRQRWIRUFHWKHWULPPHUKHDGLQWRXQFXWJUDVV
Ŷ7KHOLQHFDQZHDUTXLFNO\DQGHYHQEUHDNZKHQXVHGDJDLQVWVROLGVXUIDFHVVXFKDVIHQFHV
borders, curbs and walls made of metal, wood, stone and brick. Avoid using the trimmer against
these materials.
ADVANCING LINE (See Fig. 30)
This trimmer uses a line advance system which requires the operator to tap or bump the trimmer head
on the grass while running the engine at full throttle.
Ŷ5XQWKHHQJLQHDWIXOOWKURWWOH
Ŷ7DSWKHWULPPHUKHDGRQWKHJURXQGWRDGYDQFHWKHOLQH:LWKHDFKWDSWKHOLQHDGYDQFHVIXUWKHU$
¿UPEXWJHQWOHPRWLRQVKRXOGEHXVHGZKHQWDSSLQJWKHOLQHRQWKHJURXQG)LJ'2127NHHS
the trimmer head pressed against the ground.
NOTICE: The cutting blade on the underside of the debris guard will cut the line to the correct length.
NOTICE: Line that is too short may not advance using the tapping method and may need to be done
manually.
Fig. 30