LawnMaster NPTGSP2617A - TROUBLESHOOTING; Engine Not Starting Issues

37
TROUBLESHOOTING
If your grass trimmer does not appear to operate properly, follow the instructions below. If this does not
solve the problem, please contact your local repair agent.
WARNING
Before proceeding, shut off the engine, wait for all moving parts to stop, and remove the battery pack.
Failure to follow these instructions can result in serious personal injury or property damage.
PROBLEM POSSIBLE CAUSE SOLUTION
The engine does not
start.
The battery is not secure.
Insert the battery correctly. Ensure the
battery is fully charged.
No spark.
Clean or replace the spark plug. Reset
the spark plug gap. Refer to the Spark
Plug Replacement section in this
manual.
No fuel.
&KHFNWKDWWKHUHLVVXI¿FLHQWIXHOLQWKH
fuel tank. Push the primer bulb until the
bulb is full of fuel. If the bulb does not
¿OOWKHSULPDU\IXHOGHOLYHU\V\VWHPLV
blocked. Contact an authorized service
GHDOHU,IWKHSULPHUEXOE¿OOVWKHHQJLQH
PD\EHÀRRGHGSURFHHGWRWKHQH[W
item.
7KHHQJLQHLVÀRRGHG
Remove the spark plug referring to the
Spark Plug Replacement section in this
manual. Press the start button 5 to 10
times. Then place the trimmer still with
the spark plug removed for about 30
minutes. After 30 minutes, replace the
spark plug referring to the Spark Plug
Replacement section. Then re-start the
engine. If the engine still does not start,
contact an authorized service dealer.
7KHDLU¿OWHULVEORFNHG
&OHDQWKHDLU¿OWHU5HIHUWR&OHDQLQJWKH
Air Filter section in this manual.
The engine does not
reach full speed and
emits excessive smoke.
Incorrect lubricant/fuel
mixture.
Use fresh fuel and the correct 2-cycle
lubricant mix (40:1).