LawnMaster NPTGSS2617A - Trimming Techniques

21
GENERAL TROUBLESHOOTING
Flywheel (Rotor) Replacement (See Figs. 19-22)
Ŷ5HPRYHWKHFOXWFK
Ŷ5HPRYHWKHQXWXVLQJDQLPSDFWGULYHU)LJ
Ŷ5HPRYHWKHVFUHZVWRUHPRYHWKHÀ\ZKHHOFRYHU)LJ
Ŷ7KHÀ\ZKHHOFDQEHUHPRYHGE\DSXOOHU)LJ&KRRVHDQDSSURSULDWHSXOOHUWRUHPRYHWKH
À\ZKHHO%HIRUHXVLQJWKHSXOOHUURWDWHWKHVFUHZURG counter-clockwise to its 1/4 to 1/2 length.
Ensure the screw rods and are protruded longer than screw rod . Rotate the screw rods
and clockwise into the corresponding threaded holes as shown in Fig. 21. Make sure screw rods
and are level and in same length. Then use a spanner to rotate the screw rod clockwise
XQWLOWKHÀ\ZKHHOLVUHPRYHG5RWDWHWKHVFUHZURGV , and counter-clockwise to remove the
SXOOHUIURPWKHÀ\ZKHHO
Ŷ7XUQWKHFOXWFKXSVLGHGRZQDQGVOLGHWKHÀDWZDVKHUVRQWRWKHEROWV$SSO\WKHWKUHDGORFNLQJJOXH
for 3-5 screw threads and then re-install the clutch (Fig. 17 & 18).
Fig. 18Fig. 17
Fig. 19 Fig. 20
1
1
1
1
2
2
2
2
3
3
3
3