100 x 190mm
1. HOW TO INSTALL BATTERIES
La-z-boy recommends the use of alkaline batteries in our
remotes for longest battery expectancy. The number of
batteries required is stated on the back of the coversheet.
1. Remove the battery cover on the back of your
La-Z-Boy remote (LR).
2. Check the polarity of the batteries and the "+/-"
marks inside the battery compartment.
3. Insert the batteries.
4. Push the battery cover back in place.
Battery Low
If the indicator flashes twice slowly after using the LR, it
shows that the battery level is low. You must replace
them with new batteries to ensure proper functioning.
Note:
4 AAA batteries required (not included).
GETTING STARTED
A few helpful hints on terms used in this manual.
LR:
La-Z-Boy Universal Remote Control.
LED:
The red indicator light that flashes with an infra-red
command to your equipment.
Backlighting:
The blue backlighting on the keypad of your La-z-boy
remote. Backlighting turns on each time a key is pressed
and will turn off 8 seconds after the last key is released.
Battery Low:
If the red LED indicator flashes twice after activating
any command, it shows that the battery level is low. You
must replace the batteries with new batteries to ensure
proper functioning of your remote.
Note:
When replacing batteries you have approximately 5 mins
before your programmed codes are lost. All factory
program codes will remain in memory permanently.
Shift:
The shift key allows you to access secondary functions
th th
of the remote and to operate the 5 thru the 8 device
(AUX 1-4). Please follow the instructions in this manual.
76
To Next Page
Loading...
Need help?
General