29
For HELP, call La-Z-Boy
® Spas at 1.800.465.2933.
Mode
Depending on system configuration, mode changing may not be available and will be
locked in Standard Mode. Mode is changed by pressing “Temp,” then “Light”.
Standard Mode maintains set temperature. will be displayed momentarily when
you switch into Standard Mode. Economy Mode heats the spa to the set temperature
only during filter cycles. will display when water temp is not current, and will
alternate with water temp when the pump is running. Sleep Mode heats the spa to
within 20°F/10°C of the set temperature only during filter cycles. will display when
water temp is not current, and will alternate with water temp when the pump is running.
Press the button to display the set temperature, and again to make the temperature
change in the desired direction. To display the set temperature, press the temperature
button once. To change the set temperature, press the temperature button again
before the display stops flashing. Each press of the temperature button will adjust the
set temperature. After three seconds, the display will stop flashing and begin to display
the current spa / hot tub temperature.
Pump 1
Press “Pump 1” to turn pump 1 on or off, and to shift between low and high speeds.
The low-speed will turn off after 4 hours. High-speed will turn off after 15 minutes. Low-
speed may run automatically at times, during which it cannot be deactivated from the
panel, but high-speed may be operated.
Pump 2
Press the corresponding button once to turn the pump on or off. The pump will turn off
after 15 minutes. The low-speed will turn off after 4 hours. High-speed will turn off after
15 minutes. Low-speed may run automatically at times, during which it cannot be
deactivated from the panel, but high-speed may be operated.
Light
Press “Light” to operate the spa / hot tub light. The light automatically turns off after 4
hours. Continue to press the light button to change the light color or to activate the light
sequencing feature.
To Next Page
Loading...
