36
For HELP, call La-Z-Boy
® Spas at 1.800.465.2933.
How do I bleed air from my system?
When draining and refilling your spa / hot tub, the pump may become air locked.
Air-locked pumps stop water from flowing in your spa / hot tub and is easily resolved by
bleeding off the trapped air. To do this:
• Turn off the GFCI breaker
• Open the access panel below the topside control panel
• Loosen the union on the circulation pump until you hear the trapped air escape
• Once water drips out in a continuous stream, hand tighten the union until the water
stops leaking
• Loosen the discharge union on Pump 1 & 2 (if equipped) as below
• Turn on all pumps to make sure that there are no leaks
• Put the access panels back on
• Turn on the GFCI breaker
Figure 15 - Bleeding Air
How should I clean my spa?
Use non-sudsing cleaners and non-oily polishes. A high quality all purpose cleaner
quickly removes scum lines and helps restore your shell’s original beauty. Rinse all
filters, covers, pillows, and surfaces thoroughly with warm tap water. A high quality
filter cleaner is a safe, effective way to clean and re-use your filters and a plumbing
cleaner cleans the inside of all plumbing in your spa / hot tub. You can contact your
local La-Z-Boy Spa dealer to order these easy-to-use cleaning products.
To Next Page
Loading...
