EasyManua.ls Logo

LCT 79cc - Engine Oil Level Check; Engine Oil Change Procedure

Default Icon
27 pages
Print Icon
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Loading...
Copyright © 2018 Liquid Combustion Technology, LLC LCT Engine Service Manual: 79, 136, 179, 208, 254, 291, 306, 369, 414 & 420cc 11
Max Upper
Level
Max Lower
Level
Engine Oil Level Check
Check the engine oil level with the engine stopped and with the engine in a level position.
1. Remove either side mounted ller cap dipstick or high oil ll dipstick and wipe it clean.
2. Insert the dipstick into the ller neck and turn clockwise until fully seated. Then remove the dipstick by turning it counter clockwise.
Check the oil level shown on the dipstick.
3. If the oil level is low, ll to the edge of the oil ller hole with the recommended oil.
4. Securely screw in the ller cap/dipstick. Running the engine with a low oil level can cause engine damage.
Always check the engine oil before start up.
Engine Oil Change
Engine Oil
Recommendations
Engine oil affects performance and service life. Use 4-stroke automotive
detergent oil.
SAE 10W-30 is recommended for general use. Other viscosities shown in
the chart may be used when the average temperature in your area warrants.
The SAE oil viscosity and service classication are in the API label on the oil
container. The manufacturer recommends you use API SERVICE category
SJ engine oil, or better.
Fill if oil is
below letter
“L” on the
filler cap
Fill if oil
is below
“Add”
on the
dipstick
Engine Oil Capacities
79cc 13 oz (.384 liter)
136cc/179cc/208cc 16 oz (.473 liter)
254cc 20 oz (.591 liter)
291cc/306cc 32 oz (.946 liter)
369cc/414cc/420cc 38 oz (1.123 liter)
Drain the used oil while the engine is warm. Warm oil drains quickly and
completely. Avoid contact with hot oil.
1. Place a suitable container below the engine to catch the used oil then remove
the ller cap/dipstick and the drain plug.
2. Allow the used oil to drain completely, then reinstall the drain plug, and
tighten it securely. Do not over tighten. Dispose of used motor oil in a
manner that is compatible with the environment. We suggest you take used
oil in a sealed container to your local recycling center or service station for
reclamation. Do not throw used oil in the trash, pour it on the ground, or pour
down a drain.
3. With the engine in a level position, ll to the outer edge of the oil ller hole
with the recommended oil. (see ll limits right)
• NOTICE Running the engine with a low oil level can cause engine damage.
4. Securely screw in the ller cap/dipstick.
ALL
MODELS
179, 208, 254cc
ONLY

Related product manuals