LDG DTS-6 - Page 11

11
Codes sent by the DTS-6R remote to the DTS-6 switch
R 00 - Remote is telling main unit that buttons 4&5 were pushed – user wants to ground all
antennas.
R 01 - Not used. Remote doesn’t give the command to ground all.
R 02 - Remote tells main unit that button 1 is selected – user wants to select antenna 1.
R 03 - Remote tells main unit that button 2 is selected – user wants to select antenna 2.
R 04 - Remote tells main unit that button 3 is selected – user wants to select antenna 3.
R 05 - Remote tells main unit that button 4 is selected – user wants to select antenna 4.
R 06 - Remote tells main unit that button 5 is selected – user wants to select antenna 5.
R 07 - Remote tells main unit that button 6 is selected – user wants to select antenna 6.
R 09 - Remote asks main for the current antenna position. Expects a response from main of “M
00,” “M 01,” “M 02,” “M 03,” “M 04,” or “M 05”.
R 10 - Remote tells main that the user wants to turn the radio sense mode off.
R 11 - Remote tells main that the user wants to turn the radio sense mode on.
R 12 - Remote asks main for current radio mode. Expects a response from main of “M 10” or
“M 11”.
R 14 - Not used.
R 17 - Remote tells main that it does not detect radio power.
R 18 - Remote tells main that it has radio power.
R 19 - Not used.
R 20 - Remote asks main to do a self-check. Remote expects a response of “M 21” to show
the remote has started the check. If “M 21” is not received, then remote flashes LEDs 1 and 4. If
“M 21” is received, remote will scroll the LEDs and wait for another response.
R 21 - Remote tells main that its self-check returned no errors.
R 22 - After doing a self-check, everything is correct, so remote tells main.
R 23 - After doing a self-check, button 1 is stuck, so remote tells main.
R 24 - After doing a self-check, button 2 is stuck, so remote tells main.
R 25 - After doing a self-check, button 3 is stuck, so remote tells main.
R 26 - After doing a self-check, button 4 is stuck, so remote tells main.
R 27 - After doing a self-check, button 5 is stuck, so remote tells main.
R 28 - After doing a self-check, button 6 is stuck, so remote tells main.