LDR Aria f1000 plus Series User Manual

LDRAriaf1000&Ariapc1000User’sManual–1.0
LucidellaRibaltasrl,ViaBerna14,46042CastelGoffredo(MN)Italy
Tel.+390376771777–fax+390376772140–emailinfo@ldr.it–webwww.ldr.it
4
• protectthelampfromabrasionandscratches.Donotinstallorusecrackedorbrokenlamps.Incasea
lampcracksorbreaks,disconnectfrompowersupply,allowtheunittocoolandremove/replace the
brokenlamp
• nevertouchthelampbulbwithbarehands.Oilandgreasecan
contaminatethequartzsurfaceand
reducethelampperformanceandlife
• donotremovetheplasticprotectionaroundthelampuntilafterhavinginstalledthelamp
• openthetopslidingcoverbyturning(anti‐clockwise)the¼turnfastener.Atool,suchasascrewdriveror
acoin
willbeneeded.Slidethecoveropentohavefullaccesstothelamphouse.
• insertthelampinthelampholder.MAKESURETHELAMPISCORRECTLYPOSITIONEDANDPERFECTLY
VERTICAL.
• carefullyclosethetopslidingcoverbyturning(clockwise)the¼turnfastener


7. INSTALLATION
Thisproduct
isfittedwithasuspensionstirruprotatingaroundthebodyoftheproduct,thusallowingthe
producttobeinstalledsuspendingorstanding.ThestirrupisfittedwithaØ12mmclearholeforthe
attachmentofahookclamporastandpivot.
Beforeinstallingthisproductmakesurethe
structureyouarefixingtheproducttocanwithstanditsload
andthetotalloadofanyotherunitinstalled.

1. Hangtheunittothestructureandfirmlytightentheclamp.
2. Fixthesafetybond


8. CONNECTTOTHEPOWERSUPPLY
• Makesuretheplugyouare
fittingwithstandsthelamppowerload.
• Thisfixturemustbegrounded
• Toperformacorrectwiring,pleasenotethatthecoresinthismainsleadarecolour‐codedasfollows:
Ground:green+yellow–Neutral:blue‐Live:brown

Incasethecoloursofthecoresdonotcorrespondto
thecolouroftheconnectionpointsonyourplug,
pleaseproceedasfollows:
• Thegreenorgreenandyellowcoremustbeconnectedtotheconnectionpointmarked
withtheletterEorwiththesymbol
orcolouredingreenoringreen‐yellow
• ThebluecoremustbeconnectedtotheconnectionpointmarkedwiththeletterNorwith
thesymbol
orcolouredinblack
• ThebrowncoremustbeconnectedtotheconnectionpointmarkedwiththeletterLor
withthesymbol
orcolouredinred

• Beforeyoufinallypositionthisproductforuse,temporarilyconnectittoaproperlyfusedpowersupply
tocheckthelampworkscorrectly.
• Protecteachproductwithafusesuitabletothelampyouareusing.Shouldyouconnectthisproductto
adimmer
pack,pleasemakesurethisisfittedwithsuitableprotectivefuses.


9. CLEANINGANDMAINTENANCE
Toensuremaximumperformanceoftheproduct,aregularmaintenanceserviceshouldbecarriedout.
Pleasemakesuretheproductiscoldanddisconnectedfrompowersupplywhendoingthis.

• cleanallreflective
partssuchasreflector,mirrorandlensopeningtheproduct,ifnecessary.

LDR Aria f1000 plus Series Specifications

General

Brand	LDR
Model	Aria f1000 plus Series
Category	Light Fixture
Language	English