Le Chai LB720V - Page 131

EN-131
d3: brightest setting
▪ Touch and hold the UP
▪ Touch the POWER key to confirm your selection.
key for 5 seconds to leave settings mode. Otherwise the appliance exits
settings mode automatically after approximately one minute.
Interior Lighting Brightness
▪ Lightly touch and hold the UP key for 5 seconds and then touch the POWER key twice.
▪ Use the UP and DOWN keys to select the brightness of the interior lighting. The factory default setting
is L3.
L0: off (when the door is closed or open)
L1: dimmest setting
L2: medium setting
L3: brightest setting
temperature is reached again. However, if the noise disturbs you, you can switch the audible alarm
off before this if you wish by pressing the POWER key once. The alarm will stop. The relevant
when rearranging and removing storage items.
- When the door is not been closed tightly.
- The appliance is faulty.
The audible alarm will be automatically silenced and the temperature display stops flashing when the
temperature set.
- When there has been a lengthy interruption to the power supply.
- When too many items have been put into the unit at one time. Or too much ambient air flowed
range. The relevant temperature display will flash at the same time. The temperature the appliance is
set at determines the temperature the appliance recognizes as being too warm or too cool. The
audible alarm will sound and the temperature display will flash:
- When you switch the appliance on, if the temperature inside the appliance is very different from
settings mode automatically after approximately one minute.
TEMPERATURE MEMORY FUNCTION
In the event of a power interruption (power surge, breaker switch, etc.), the unit remembers the previous
temperature settings. When the power is recovered, the cabinet temperature will go back the same
setting temperature as before the power interruption.
TEMPERATURE ALARM
An audible alarm will sound if the temperature in one of the zones rises or falls outside the temperature
▪ Touch and hold the UP key for 5 seconds to leave settings mode. Otherwise the appliance
▪ Touch the POWER key to confirm your
S0: sensor tone ON, alarm tone OFF
S1: sensor tone ON, alarm tone ON
S2: sensor tone OFF, alarm tone OFF
S3: sensor tone OFF, alarm tone
▪ Use the UP and DOWN keys to select the audible tones. The factory default setting is
▪ Lightly touch and hold the UP key for 5 seconds and then touch the POWER key four
settings mode automatically after approximately one minute.
Audible
▪ Touch and hold the UP key for 5 seconds to leave settings mode. Otherwise the appliance
▪ Touch the POWER key to confirm your
F0: Silent mode - Energy saving mode
F1: Dynamic Cooling mode - half time
F2: Dynamic Cooling mode - full
▪ Use the UP and DOWN keys to select the fan mode. The factory default setting is
▪ Lightly touch and hold the UP key for 5 seconds and then touch the POWER key three
settings mode automatically after approximately one minute.
Fan
▪ Touch and hold the UP key for 5 seconds to leave settings mode. Otherwise the appliance
▪ Touch the POWER key to confirm your selection.
exits
Mode
times.
F0.
time
selection.
exits
Tones
times.
S1.
ON
selection.
exits
the
in
s
et