CONNECT THE LPG CYLINDER
Turn the control
knobs to OFF.
❶
Ensure that the LPG cylinder
is OFF by turning the OPD hand
wheel clockwise to a full stop.
Remove the safety cap from
the Type
valve outlet.
REGULATOR SAFETY
• Use this appliance, as purchased, only with gas and regulator/valve assembly supplied.
• DO NOT cross thread the connection between your LPG cylinder and regulator.
Cross threading can occur if you force thread a connection at an improper
angle. This will damage the threads, lead to propane leaking, and potentially
result in a build-up of fuel that can ignite.
• If you can not connect the regulator, DO NOT use the regulator.
Regulator must be replaced with a Blackstone approved model by a profession-
ally licensed, authorized dealer.
❶
❷
Hold the regulator in a
straight line with the Type
valve outlet so as not to cross
thread the connection.
Center and insert the regu-lator
nipple into the Type
valve
outlet.
Hand-tighten the coupling nut in
a clockwise direction.
(DO NOT use tools to connect.)
If connection cannot be completed,
disconnect regulator and repeat this
step.
Coupling nut
Regulator nipple
Set the LPG cylinder on
the cart base. Tighten the cart
base wing screw to secure it to
the appliance.
The safety relief valve must face
away from the user while the
appliance is in use.
control knob to HUGH control knob to HIGH position.
12
To Next Page
Loading...
