© 2019 LEA Professional. All Rights Reserved.
GLOSSARY | FeaturesDefinitions CONTINUED
Bandpass Gain: This bandpass gain block
is located after the crossover points and allows
the user to boost or reduce the gain by +/- 15dB
Output Polarity: This is a user adjustable
polarity setting after the crossover points
allowing the user to invert the output signal.
Delay: 100milliseconds of delay is available in
the connect series amplifiers.
Parametric EQ Filters: 8 user adjustable
parametric filters are available per channel.
Speaker Limiter: The speaker limiter
allows the user to set output voltage limiting
conditions in place to protect the speakers
attached to the output. VRMS limiter settings
prevent overheating while V Peak limiter setting
prevent the speaker form over exerting.
Amplifier Protection Limiter: In the
event the amplifier needs to limit the output to
protect itself, the amplifier protection limiter will
automatically enable itself. The amplifier
protection limiter can enable itself if the amplifier
is running in the upper limits of its’ thermal
capacity or if AC voltage drops below a
threshold where it can deliver full power to the
output. This is a factory setting meant to keep
the amplifier operating safely.
Realtime Load Monitoring: This feature
allows the user to monitor the load impedance of
any channel in Realtime. Once there is more
than 5 VRMS on the output, the amplifier will
automatically test the impedance of each
channel and report it’s reading in the web
browser-based UI.
Pilot Tone Monitoring: This is an
advanced feature that is intended to
send an
inaudible tone through the output so the user
can monitor the impedance of the speakers
connected to the output without having to send
input signal.
Saving and Loading Speaker Tuning
Files: Saving speaker tuning files in the web
browser-based UI saves all the information in
the crossover, parametric EQ, limiter, and load
monitor section of the amplifier channel.
Loading speaker tuning files loads all of the
information into the crossover, parametric EQ,
limiter and load monitor section of the amplifier
channel.
Saving and Loading Amplifier
Settings: Saving amplifier settings in the web
browser-based UI saves all of the information
from the amplifier and it’s up to 4 channels of
information. Loading amplifier settings in the
web browser-based UI loads all of the
information from the amplifier and it’s up to 4
channels of information.
To Next Page
Loading...
