2. If you have not already done so, follow the instructions under Get Started to install the LeapFrog® Connect
application.
3. Follow the instructions in the LeapFrog® Connect application to set up your LeapStart® system and download
companion audio and video for each of your books. The Power Light will flash in about one second intervals
when content is downloading.
4. Eject and disconnect the LeapStart® system from your computer.
5. To begin playing, simply touch the tip of the LeapStart® stylus to any image or word in your LeapStart® activity
book.
Automatic Shut Off
The system will turn off automatically if not used for several minutes.
Power Light Indication
The Power Light on the LeapStart® Go system has different behaviors in the circumstances below:
Circumstance Power Light Behavior
System On Green
Charging Status* Amber
Charging Status
(when connected to LeapFrog® Connect)
Red and amber flashing in about 1 second intervals
Charging Complete Green
Charging Complete
(when connected to LeapFrog® Connect)
Green flashing in about 1 second intervals
Bad Unit Green, red or amber lights flashing rapidly
* If there is an issue charging the battery, such as the battery not getting enough power or being outside of the
normal temperature range, the power light will show green.
Instructions for Care and Use
For indoor, dry-location use only. Do not use the product near a sink or other wet locations. Take care not to spill
food or any kind of liquid on this product as it may render it inoperable and not serviceable. In case the unit does get
wet, unplug all cables and turn it OFF. Allow to dry thoroughly before reusing. Do not attempt to dry with a hair dryer
or other heat source.
Avoid prolonged exposure to extreme temperatures and direct sunlight. Operate in places with temperatures
ranging from 5°C (40°F) to 38°C (100°F). Do not leave the product in your car as the temperatures in parked cars
can exceed the acceptable storage temperature. Exposure to extreme temperatures can result in shortened battery
life or cause the product to temporarily stop working.
Handle with care. To avoid injury, damage to this product or other property, avoid dropping and never disassemble,
crush, puncture, microwave, incinerate, insert foreign objects or paint the product. Clean your hands before handling
the product if they have been exposed to suntan lotions or other chemicals.
Cleaning. Disconnect all cords before cleaning. Clean the product with a slightly damp cloth (cold water). Do not use
soap, detergent or other chemicals. Never submerge the unit in water. Allow to dry thoroughly before using again.
Repairing or Modifying LeapStart® Go System
Never attempt to repair or modify as the LeapStart® Go System does not contain any user-serviceable parts. Service
should only be provided by LeapFrog® Enterprise, Inc.
If the product has been in contact with liquids, punctured, or subjected to a severe impact or fall, immediately remove
this product from use and contact LeapFrog®
To Next Page
Loading...
Need help?
General
