4
INSTRUCTIONS
Battery Removal and Installation
1. Make sure the unit is turned OFF.OFF.
2. Locate the battery cover on the back of the unit. Use a
screwdriver to loosen the screw and then open the battery
cover.
3. If used batteries are present, remove these batteries from
the unit by pulling up on one end of each battery.
4. Install 4 new AA (AM-3/LR6) batteries following the diagram
inside the battery box. (For best performance, alkaline
batteries or fully charged Ni-MH rechargeable batteries are
recommended.)
5. Replace the battery cover and tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
To Next Page
Loading...
Need help?
General