LeapFrog My Pal Scout Smarty Paws - Getting Started; Personalization

4
GETTING STARTED
PERSONALIZATION
Step 1
Using a smartphone, tablet or
computer with a 3.5mm headphone
jack, go to leapfrog.com/SmartyPaws.
Follow the instructions to select your
child’s name and favorite things.
For a list of supported browsers, see
System Requirements on the opposite
side of this guide.
Step 2
Open the hook-and-loop fastener on the back of Scout to
accessthebatterybox.Useascrewdrivertoloosenthescrew
andslideopenthebatteryboxdoortorevealtheCable. Slide
the On/O/Volume Control Switch to the On position.
When prompted by the website, connect the Cable in Scout’s
batteryboxtothe3.5mmheadphonejackoradapteronyour
smartphone, tablet or computer. Do not plug the Cable into
peripheralorexternalaccessoriessuchasspeakers,docks,
etc. Follow the instructions on the website to begin the
download.
Step 3
When personalization is complete, disconnect the Cable from
your device and tuck the Cablebackintothebatterybox.
Closethebatteryboxdooranduseascrewdrivertotighten
the screw to secure. Close the hook-and-loop fastener over
thebatterybox.