LeapFrog My Pal Scout Smarty Paws - Battery Installation; Important: Battery Information

5
BATTERY INSTALLATION
1. MakesuretheunitisturnedOff.
2. Find the battery cover located
on the back of the unit, use a
screwdriver to loosen the screw,
and then open the battery cover.
3. Remove old batteries by pulling
up on one end of each battery.
4. Install 2 new AA (LR6/AM-3)
batteries following the diagram
inside the battery box. (For
best performance, alkaline
batteries or fully charged Ni-
MH rechargeable batteries are
recommended.)
5. Replace the battery cover and
tighten the screw to secure.
WARNING
Adult assembly needed. Close the battery door and tighten
the screw to secure before giving your child the toy.
ATTENTION
L’assemblage doit être effectué par un adulte. Fermer puis
revisser fermement le couvercle du compartiment à piles
avant de donner ce jouet à un enfant.
IMPORTANT: BATTERY INFORMATION
• Insertbatterieswiththecorrectpolarity(+and-).
• Donotmixoldandnewbatteries.
• Donotmixalkaline,standard(carbon-zinc)orrechargeable
batteries.
• Onlybatteriesofthesameorequivalenttypeasrecommended
are to be used.