LeapFrog On-the-Go Story Pal - Device Power and Activation; Battery Installation and Play Mode Activation

4
INSTRUCTIONS
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located
on the back of the unit, use a
screwdriver to loosen the screw
and then open the battery cover.
3. Remove old batteries by pulling up
on one end of each battery.
4. Install 3 new AA (AM-3/LR6)
batteries following the diagram
inside the battery box. For best
performance, alkaline batteries or
fully charged Ni-MH rechargeable
batteries are recommended.
5. Replace the battery cover and
tighten the screw to secure.
WARNING:
Adult assembly required for battery installation.
Keep batteries out of reach of children.
ATTENTION :
Les piles ou accumulateurs doivent être installés par un adulte.
Tenir les piles ou accumulateurs hors de portée des enfants.