10
Wireless Controller
1. Turn off the Wireless Controller with the Power Switch on the back
of the controller.
2. Interrupt the power supply by removing the batteries.
3. Let the unit stand for 10 seconds, then replace the batteries.
4. The unit will now be ready to play again.
5. If the unit still does not work, replace with an entire set of
new batteries.
OTHER NOTES
Static electricity may cause the HDMI Game Stick to malfunction. In cases
where the HDMI Game Stick is malfunctioning due to static electricity,
disconnect the Micro USB Power Cable, wait for 10 seconds, then
reconnect the Micro USB Power Cable to reboot the HDMI Game Stick.
FCC Compliance Statement
After completing the steps in the Initial Setup section, power on the
television. FCC e-labeling will be shown on the television for the U.S.
version of PAW Patrol: To the Rescue! Learning Video Game.
This screen confirms that this product complies with FCC regulations.
IMPORTANT NOTE:
If the problem persists, please call our Consumer Services
Department at 1-800-701-5327 in the U.S. and Canada, or email
support@leapfrog.com. Creating and developing LeapFrog
products is accompanied by a responsibility that we take very
seriously. We make every effort to ensure the accuracy of the
information, which forms the value of our products. However,
errors sometimes can occur. It is important for you to know that
we stand behind our products and encourage you to contact us
with any problems and/or suggestions you might have. A service
representative will be happy to help you.
To Next Page
Loading...
