3
ATTENTION
Pour la sécurité de votre enfant, débarrassez-vous de tous les produits
d’emballage tels que rubans adhésifs, feuilles de plastique, attaches,
étiquettes et vis d’emballage. Ils ne font pas partie du jouet.
NOTE
Il est conseillé de conserver ce guide des parents car il comporte des
informations importantes.
GETTING STARTED
INITIAL SETUP
1. Plug the USB B Connector end of the Micro USB
Power Cable into the USB B port on the HDMI
Game Stick.
2. Plug the HDMI Game Stick into an HDMI port on
your television.
3. Plug the USB A Connector end of the Micro USB
Power Cable into a USB port on your television
or other qualified DC 5V adapter with output no
less than 500mA.
4. Make sure your television is set to display the
same HDMI port that the HDMI Game Stick is
plugged into.
5. Find the battery cover located on the back of the
Wireless Controller, use a screwdriver to loosen
the screw and then open the battery cover.*
6. Remove old batteries by pulling up on one end
of each battery.
7. Install 2 new AA (AM-3/LR6) batteries
following the diagram inside the battery box.
(For best performance, alkaline batteries or
fully charged Ni-MH rechargeable batteries are
recommended.)
8. Replace the battery cover and tighten the screw
to secure.
9. Turn the power switch on the device to On.
To Next Page
Loading...
