4
INSTRUCTIONS
Battery Removal and Installation
1. Make sure the unit is turned Off.
2. Find the battery cover located on the back of the unit, use a
screwdriver to loosen the screw and then open the battery
cover.
3. Remove old batteries by pulling up on one end of each
battery.
4. Install 3 new AAA (AM-4/LR03) batteries following the
diagram inside the battery box. (For best performance,
alkaline batteries or fully charged Ni-MH rechargeable
batteries are recommended.) (see remark 3)
5. Replace the battery cover and tighten the screw to secure.
To Next Page
Loading...
