www.lec-commercial.co.uk 8
Before you plug your appliance in
IMPORTANT: Ensure that the Lec Commercial bottle cooler is left for 2 hours before
use to allow the refrigerant to settle.
It is essential that you clean the interior of your bottle cooler BEFORE using it for the
first time. The interior should be wiped with a soft cloth dampened with a solution of
one teaspoonful of Bicarbonate of soda to one litre of lukewarm water. Rinse with clean
lukewarm water, and dry thoroughly.
DO NOT use soaps, wire wool, scouring powder or disinfectants of any kind.
Using Appliance for First Time
When unpacking and cleaning are complete plug the mains lead of your appliance into a
suitable earthed socket and switch on.
IMPORTANT: When using the bottle cooler for the first time, it is essential that you
allow it to run for 24 hours before filling to ensure it is working properly.
Note: This appliance has been supplied with a factory pre-set temperature of +3°C.
Important Refrigerant Information
The entire Lec Commercial ECA bottles cooler range contains environmentally-friendly,
non ozone depleting R600a refrigerant.
WARNING: Do not damage the refrigerant circuit
As R600a is a flammable gas, it is essential to avoid damage to the refrigeration
circuit during transportation and installation. If the refrigeration circuit is damaged,
avoid using a naked flame in the vicinity of the refrigerator and connecting power to the
refrigerator. Also make sure there is good ventilation within the room.
To Next Page
Loading...
