Lec CL 157 - Electrical Connection

7
GB/IE
Connection to the power sup ply sys tem
If the xed power supply cable is damaged, it should be replaced by the manufacturer
or at an authorized servicing outlet, or by a qualied person to avoid danger.
Electrical connection
The appliance is intended for connection to alternating current. The connection values
for voltage (V) and frequency (Hz) are given on the nameplate in the cabinet.
Power must be connected via a wall socket with switch. The wall socket should be
easily accessible.
All earthed requirements stipulated by the local electricity authority must be observed.
The cabinet plug and wall socket should then give correct earthed. If in doubt, contact
your local supplier or an authorized electrician.
WARNING – This appliance must be earthed
The exible cord (mains lead) tted to this appliance has three cores for use with a
3-pin 13-amp or 3-pin 15-amp plug. If a BS 1363 (13-amp) fused plug is used, it should
be tted with a 13-amp fuse.
● Any modication of the refrigerating
system is prohibited. Be especially careful
not to do any damage to the capillary tube
(Phot. 3 (1)) located in the recess next
to the compressors. The tube cannot be
bent, straightened or coiled. Damage of
the capillary tube by the user waives the
guarantee of the refrigerator.
3
1
▐
▼
Note:
First connection to the mains.
The appliance provides information about the higher
temperature (Hi alarm ) till the moment of cooling.
The alarm is signalised by a sound signal and “Hi"
caption on the display.
To cancel the alarm, press any push button.
Until the moment of cooling, the alarm is repeated
every 15 minutes.
Such an operating mode is normal until the required
temperature settings are reached.