Getting to know your appliance
Before you switch on
fridge
larder
2
consider the location
The room must have a volume of 1m
3
for
every 8g of refrigerant R600a inside the
appliance. The quantity of gas in the
appliance can be found on the data plate.
To help you avoid pushing your elan too far
back against a wall, a spacer has been
provided. It fits as shown below.
Your elan should not be installed on a
carpet, this may prevent proper air
circulation.
Your elan product has been designed to
operate in the following room temperatures:
Larder between 10°C and 32°C
Refrigerator between 16°C and 32°C
Do not locate your elan near a heat source,
e.g. cooker, boiler or radiator. Avoid placing
in direct sunlight. An unheated garage or
outbuilding is also inappropriate.
When installing it is important to keep a
minimum clearance of 25mm (1”) all around
the cabinet to allow for ventilation.
unpack your elan
Remove all external and internal packing.
decide on the door opening
The door can open on its right or left hand
edge to suit the location, see the section on
reversing the door opening.
clean your elan
We recommend that you clean your elan
before use, refer to the section ‘Cleaning
your elan.’
leave your elan for 2 hours
Before switching on leave your elan upright
for 2 hours to allow the coolant fluid time to
settle.
ensure your elan is level
Where fitted, adjust the rotating feet at the
front. A very slight backward lean will ensure
that the door closes better.
3
To Next Page
Loading...
