6
Installation and removal of shelves:
GB/IE
Placement of the product
● Unpack the product; remove the tape securing the door and the accessories. Re-
move the remains of the glue, if any, with delicate cleaning detergent.
● Do not throw the Styrofoam element of the packaging away. Should you have to
transport the product again, secure the refrigerator with the Styrofoam elements, the
plastic foil, and Scotch tape.
● Wash the inside of the refrigerator chamber and the accessories with lukewarm
water with some dishwasher liquid and then wipe it and dry.
● Place the refrigerator in a dry, ventilated place, out of sun, far from heat sources
such as central heating radiators, etc.
- at least 30 cm from oil or coal-red stoves.
● If you place the refrigerator next to another refrigerating or freezing unit, the lateral
distance be twe en the ap plian ces should be at least 2 cm.
● Make sure the product is placed level ad ju sting two turn-in front feet of the re fri ge ra tor.
● Once placed, make sure the refrigerator is not standing on the power supply cord.
Before You Start
The PE 507, PG 507 refrigerator is equipped with a cover top and is designed to t
under a standard 865 mm high counter or bench top.
● For easy opening of the refrigerator door the distance between the side (the hinges
side) and the room wall (or similar) should be at least 5 cm.
● In order to remove a shelf hold the right
side of the shelf, lift the left side with your
left hand about 45° and remove the shelf
(Photo 2).
● Start taking out the shelf for cleaning
with the top one, start putting them back
in with the bottom one.
● Shelves are installed as follows:
- put the shelf in at an angle about 45°
(just like taking it out)
- align the projections with the grooves
located at the sides of the refrigerator
chamber.
2
To Next Page
Loading...
