8
Operation
1. User interface (Photo 4)
Button (1) ‘ I ’ (ON /OFF) – pressed for about 2-3sec – switches on and switches off
whole product's controlling,
Button (2) ‘light’ – turns on and off the lighting, if it is not turned off, it turns off auto-
matically after 3 minutes.
Green LED diode (3) – indicates lighting turned on,
Button (4) ‘lock’ – pressed for about 2-3sec – blocks the keypad – does not refer to
button (1) driver switch off,
Green LED diode (5) – indicates active blockade function,
‘-‘ minus diode (6) – indication of temperatures below zero,
LED display (7) –temperatures, service parameters and alarm symbols display,
Button (8) ‘▼’ - minimum temperature preview or parameter value decrease,
Button (9) ‘▲’ – maximum temperature preview or parameter value increase,
Button (10) AUX – functional button,
Green LED diode (11) – indication of temperature programming mode – manual
switch of AUX output,
2. First start up
After switching on, the driver activates the auto-test procedure. During the rst se-
cond, it displays dots, program version during next second, dots during the third
second and then switches to a normal work mode.
During the normal work mode, the display shows the temperature of a cooler. In case
of alarm, it displays E with an alarm number.
If the door is open, a „dr” symbol appears on the display (version with the option of
a door sensor).
If the driver is switched off, LED diodes are turned off and the display shows two
horizontal lines.
The display indicates temperature of the cooler within the range of –30
o
C to +30
o
C
GB/IE
4
To Next Page
Loading...
