7.8 Attaching the
headrest
To attach the Leckey head headrest first
open the locking lever by pressing the
safety button and pulling the handle, then
remove the plastic insert from the receiving
collar. Then slide the stem into the receiving
bracket on the central spine, set to the
desired position and secure using the
locking handle.
The Whitmyer Lynx head support attaches
in the same way. To attach the Whitmyer
Pro-Series headsupports remove the spacer
collar from the receiving bracket and lock
the vertical stem in position using the
locking lever.
The product contains components which
could present a choking hazard to small
children. Always check that locking knobs
and bolts within the child’s reach are
tightened and secure at all times.
7.9 Inserting
Attachment Bolt
Insert the required attachment bolt (a)
along with the retention plate (b). Place a
rubber lid (c) on, both, the top and bottom
of the sandal. Fasten using the four screws
(d) provided. To remove or replace the
attachment bolt, reverse this process.
A1
2
B
C
D
To Next Page
Loading...
