p.26 Squiggles
+
Stander User Manual
10.7 Grab rail adjustment
To set the depth of the grab
rail to suit the child’s reach
loosening knob
adjust to
the required depth and then
re-tighten.
To set the height of the rail,
loosen knob
slide the rail
to the required height and
then re-tighten.
10.8 Pivot chassis
angle adjustment
The angle can be adjusted
whilst the user is in the
stander. You should ensure
the child is secured in the
stander using the thoracic
and hip pads. To adjust
the angle of the stander
rst release the locking
pin. To release the pin, pull
and rotate plastic knob
through 90 degrees into the
locked position.
Press the foot pedal
down and set the stander to
the desired angle using the
handle bars. Always re-lock
the locking pin
.
Ensure that the product
and user are away from
surrounding furnishings to
prevent possible collision
when adjusting the angle
of the pivot chassis.
To Next Page
Loading...
