11
GB/IE
Electrical connection
The appliance is intended for connection to alternating current. The connection values
for voltage (V) and frequency (Hz) are given on the nameplate in the cabinet.
Power must be connected via a wall socket with switch. The wall socket should be
easily accessible.
All earthing requirements stipulated by the local electricity authority must be observed.
The cabinet plug and wall socket should then give correct earthing. If in doubt, contact
your local supplier or an authorised electrician.
WARNING – This appliance must be earthed
The exible cord (mains lead) tted to this appliance has three cores for use with a
3-pin 13-amp plug. If a BS 1363 (13-amp) fused plug is used, it should be tted with
a 13-amp fuse.
IMPORTANT
The cores in this mains lead are coloured in accordance with the following code:
GREEN-AND-YELLOW: EARTH
BLUE: NEUTRAL
BROWN: LIVE
These colours might not correspond with the colour markings identifying the terminals
in your plug.
Note:
First connection to the mains.
The appliance provides information about the higher temperature (Hi alarm ) till the
moment of cooling.
The alarm is signalised by a sound signal and “Hi” caption on the display.
To cancel the alarm, press any push button.
Until the moment of cooling, the alarm is repeated every 15 minutes.
Such an operating mode is normal until the required temperature settings are
reached.
To Next Page
Loading...
