Tesla to J1772 Adapter
User Manual
Specication
Troubleshooting
Voltage : Max 250V AC
Current : Max 40 amps
Operation Temperature : -30°C to +50°C
Charging Port : SAE J1772 Standard
Connector Port : Tesla US
Cable Length : 3.9 inches (10cm)
Weight : 1.83 lbs (0.83kg)
For more information, visit:
www.ev-lectron.com
or contact us at
contact@ev-lectron.com
Made in China
Tesla Charger not included.
Lectron is not aliated with Tesla Inc.
Lectron is a trademark of Dropcases Ltd.
Tesla is a trademark of Tesla Inc.
Page - 04
1. After connecting the Tesla charger to our adapter, please
wait 30 seconds before connecting it to the electric vehicles.
2. If you are using Tesla Destination Charger or a Tesla Wall
Connector and you see a red light blinking on the charger,
please adjust the charger current to 40A or below (i.e. set the
rotary switch to position 1-8).
3. Please make sure that the charger you are connecting to
does not exceed your EV's voltage rating.
4. Please make sure the Tesla Charger is plugged into the
adapter tightly.
To Next Page
Need help?
General
