Lectrosonics DSR4 - Audio Setup

www.lectrosonics.com 11
digital pairs (four audio channels),
into mixer or recorder inputs.
MCTA5TPT2
Audio cable for portable digital
receivers, TA5F to two stripped
and tinned wires, 18” cable. For
two analog balanced receiver out-
puts, or two AES digital pairs (four
audio channels).
MCSR/5PXLR2
Audio cable for SR-type receivers,
rotatable right-angle TA5 to two
3-pin male XLRs. 20” cable.
PS200A
Power Cable, 15 in., Hirose4 to
LZR
PS2200A
Power Cable, 15 in., Hirose4 to
Dual LZR
SNA600A Omni Dipole Antenna
Versatile Antenna, 100 MHz Band-
width tunable from 550 to 800
MHz. Includes mounting screws
and bracket. Requires SMA to
BNC Adapter.
DSR4EXT
Adapter kit for DSR4 re-
ceiver, two TA5 audio output
jacks, locking power con-
nector, includes 6’ power
cord. Has spare mounting
screws in dummy holes in
adapter.
DSR4EXTUSB Adapter
This kit includes an output
and power panel with two
TA5 male balanced output
pairs, and a locking Hirose-4
DC power jack. A USB-C
jack allows for connection
of the DSR4 to Wireless
Designer for monitoring,
channel setup, scanning,
and frequency coordination.
Firmware updates must be
done with the USB Micro B
connector on the top panel
of the unit. Power cord not
incl.; order PS200A or use
equivalent.
DSR4OCTOPACK
DSR4 mounting bezel kit
with 4 screws for Octopack
and Quadpack, no
connector included.
DSR4SUPER
DB-25 bottom plate adapter
for DSR4 receivers used in
SuperSlot docks. This in-
cludes: The end plate adapt-
er, blue bezel (PN 27315-1),
gasket and hardware set.
MCTA5TA3F2
Audio cable for portable
digital receivers, TA5F to two
TA3F connectors, 18” cable.
For two analog balanced
receiver outputs, or two AES