24
Remember that the bottom idler bar is attached to
the feed tray. If there’s no slack in the web,
the feed tray will be difficult to put on.
9. Slide the feed tray into position.
10. Flip the safety shield down into the
laminating position. Make sure there is
still enough slack in the web. Close the
laminating rollers with the large knob on
the right side of the unit. With the film
draped over the two heat shoes, push
one edge of the threading card between
the heat shoes so that the film is firmly
positioned against the laminating rollers.
Make sure the rubber rollers are in the
closed position. If a threading card is not
available, any piece of card stock or
poster board will work.
11. Make sure the slitters are disengaged (blades
in the raised position) and moved all the way to
the sides of the machine. Push the forward drive
switch. If the film and the card are in the nip
(the point where the laminating rollers meet), the
film and the threading card will start into the
laminator and will pass through both sets of
rubber rollers. When the threading card has cleared
the back of the machine, move drive switch to off.
DANGER! The safety shield must be in position over the upper heat shoe
whenever the rollers are turning or machine is heating. The laminator is designed
to be run with operator directly in front and facing the control panel, not at an
angle or from the side.
MISE IN GARDE! L’écran de sécurité doit recouvrir la plaque chauffante
supérieure lorsque les rouleaux tournent or que la machine est en train de
chauffer le materiau. La machine a plastifier est concue pour que l’operateur se
place directement en face du tableau de commande et non en biais par rapport a
celui-ci, ou sur le cote.
PELIGRO! La pantalla protectora debe estar puesta sobre la placa termica
superior cada vez que giren los rodillos o se caliente la maquina. El laminador
esta disenado para que el operador lo haga funcionar directamente por delante
mirando el panel de control, no en una esquina o desde u un costado.
To Next Page
Loading...
