3 Configuring PIN lock
Configure PIN lock to lock your Ledger Nano S Plus device after a defined period of
inactivity. The PIN code is then required to unlock it. By default, your device is locked
after 10 minutes of inactivity. It is recommended to enable PIN lock for optimal security.
Instructions
1. Connect and unlock your device using your PIN code.
2. Hold both buttons for 3 seconds to open the Control Center.
3. Go to Settings Security and press both buttons to validate.
4. Press both buttons to enter the PIN lock menu.
5. Select one of the following options:
○ No PIN lock
○ 1 minute
○ 2 minutes
○ 5 minutes
○ 10 minutes
6. Press both buttons to activate the corresponding PIN lock option.
If you've enabled PIN lock, your device will show the Ledger logo screen saver. To unlock
the device, press both buttons and enter your PIN code.
To Next Page
Loading...
