Ledj EasiLED 4 - Control Descriptions Part 2; Auto and Sound Mode Buttons; Strobe Button; DMX Output and Addressing

www.prolight.co.uk EasiLED 4 DMX Controller User Manual
7
Operating instructions
13) Auto mode button:
SelectUser/BankmodethenpresstheAutobuttontoactivateAutomodeforscene/chaseplayback.
PlaybackspeedinAutomaybecontrolledbyeithertheTap/TemportheSpeedcontrol.
14) Sound mode button:
SelectUser/BankmodethenpresstheSoundbuttontoactivateSoundmodeforscene/chase
playback.Toadjusttheinternalmicrophonesensitivity,pressandholdtheSoundbuttonanduse
thefadecontrol.
15) Strobe button:
TheStrobefunctioncanbemadeactiveinallmodesacrossthecontroller.PresstheStrobecontrol
buttontoactivateStrobemode,theredLEDwillilluminatetoconrmStrobemodeisactive.Thecontrol
forstrobeislatchingandwillremainactiveuntilthebuttonispressedasecondtime.
16) 3-Pin DMX output:
3-PinXLRsocketoutput.Pin1=Ground,Pin2=data–ve,Pin3=data+ve
17) DMX start address:
ThecontrollerhaspresetDMXstartaddressesforeachofthefourxtures.Pleasesetyourxturetothe
followingDMXaddresses.Pleasenote:IftwoormorexturesaresettothesameDMXaddresstheywill
receivethesameDMXcommands.Thecontrollercanbesetuptoaddressfourindividual3channelRGB
xturesaddressedsequentially(001,004,007and010)orifthexturesfeatureRGBWorRGBwitha
Dimmerchanneltheycanbeaddressedwithsufcientspacingbetweenthexturestoaccountforthe
extrachannels(001,017,033and049).
18) DMX channel selection:
ThecontrollercanbeusedtocontroluptofourxturesfromRGBthroughtoRGBW+Dimmer.Slidethe
switchtothepositionsuitthexturesbeingused.Pleasenote:Tooperatecorrectly,allxturesshould
sharethesameDMXchannelallocation.
19) Internal microphone/external audio select:
Thecontrollercanbetriggeredeitherviatheinternalmicrophoneorfromanexternallinelevel
audiosource.
20) Audio input:
Unbalanced6.35mm(1/4”)jacksocketforlinelevelaudioinput.
21) DC power input (centre +ve):
Centrepositivetypeconnection.9-12VDC,300mAminimumregulatedtype.
22) Power on/off switch:
Usethisswitchtopowerthecontrolleron/off.