To Next PageTo Next PageWhat to do if primer doesn’t enter case with Lee Precision Power Tool?
If primers don't enter the case when using the Lee Precision Power Tool, it might be because the primer crimp hasn't been removed. To fix this, ream or swage the primer pocket. Also, some 45ACP cases now have small primer pockets, so ensure you're using the correct size primer.
Why are there tipped primers with Lee Precision Power Tool?
If you're experiencing tipped primers with your Lee Precision Power Tool, it's likely that the case isn't fully seated in the shell plate. Adjust the case retainers to ensure the case is fully in place.
What to do if primer doesn’t feed onto priming punch of Lee Precision Six Pack Progressive?
If the primer isn’t feeding onto the priming punch of your Lee Precision Power Tool, check for oil in the trough. Remove any oil with a solvent or blow out any powder or dust with compressed air. Also, ensure the primer trough is always full, with a minimum of 5 primers for proper feeding.
How to fix primers that will not feed properly on Lee Precision Power Tool?
If primers are not feeding properly in your Lee Precision Power Tool, ensure the correct primer guide is installed and that it's oriented correctly. The letters 'S' and 'L' must face down when installed. Use Large Primer Guide # 91981 or Small Primer Guide # 91980.
Identifies major parts of the Six Pack Progressive Kit shown in the diagram.
Highlights areas requiring lubrication for press maintenance and the recommended lubricants.
Describes the features of the included Breech Lock Die Set and its benefits.
Essential safety precautions for handling ammunition and operating reloading equipment.
Guidance for operating the press smoothly and avoiding jams or double charges.
List of necessary tools and safety gear required for setting up and operating the press.
Step-by-step guide for installing the primer feed system, including guide selection.
Procedure for installing or changing the shell plate on the press.
Instructions for setting case retainers and performing a dry run to check shell plate indexing.
Guide on how to install and remove Breech Lock bushings using the provided die wrench.
Explains optimal positions for various dies within the tool head for different operations.
Details on using the Universal Expanding die in position 3 for bottleneck rifle cartridges.
Instructions for installing and using the Powder Through Expanding die in position 2.
Guide for installing and using the Full Length Sizer die for sizing and depriming in position 1.
Detailed steps for installing and filling the primer feeder, with safety warnings.
Common problems and remedies for the primer feed system, including feeding and seating issues.
Step-by-step guide for installing the Universal Case Feeder accessory onto the press.
Chart detailing shell plate, die set, and other component requirements for various cartridges.
Explanatory diagram detailing the individual parts of the shell plate carrier assembly.
General| Brand | Lee Precision |
|---|---|
| Model | Six Pack Progressive |
| Category | Power Tool |
| Language | English |
