LeeBoy 785 - Page 14

785 Motor Grader
Section 2
SPECIFICATIONS
2-4
TABLE 2-6. MACHINE SYSTEM CAPACITY SPECIFICATIONS
ITEM SPECIFICATION
Fuel . . . . . . . . . . . . . . . . . . . . . . . . . . . .50 Gallons [189.3 L]
Cooling System . . . . . . . . . . . . . . . . . . . .5.25 Gallons [19.9 L]
Crankcase . . . . . . . . . . . . . . . . . . . . . . . .2.5 Gallons [9.5 L]
Hydraulic Oil Reservoir w/oil cooler . . . . .18 Gallons [68.1 L]
TABLE 2-7. MOLDBOARD
ITEM SPECIFICATION
Length . . . . . . . . . . . . . . . . . . . . . . . . . .12 ft. 0 in. [3 m]
Height . . . . . . . . . . . . . . . . . . . . . . . . . . .20 in. [0.5 m]
Cutting Edge Thickness . . . . . . . . . . . . . .0.625 in. [1.588 cm]
Cutting Edge Width . . . . . . . . . . . . . . . . .6 in. [0.15 m]
Edge Tip Cutting Edge . . . . . . . . . . . . . .0.625 in. [1.588 cm]
TABLE 2-8. HYDRAULIC SYSTEM
ITEM SPECIFICATION
Hydraulic Pumps . . . . . . . . . . . . . . . . . .Pressure compensated load sensing
proportional Hydraulic pump system
Hydraulic Oil Reservoir w/oil cooler . . . . .18 Gallons [68.13 liters]
Hydraulic Pressure Control System . . . . .2600 PSI (Operating)
325 PSI (Standby)
TABLE 2-5. SCARIFIER
Item Front Rear
Spacing 4.5 in. [11.4 cm] 6 in. [15.2 cm]
Width 46 in. [116.8 cm] 73 in. [185.4 cm]
Lift Above Ground 17 in. [43.2 cm] 17 in. [43.2 cm]
Penetration 12 in. [30.5 cm] 12 in. [30.5 cm]
Courtesy of Machine.Market