Need help?Do you have a question about the Leeson SPEEDMASTER and is the answer not in the manual?
General| Brand | Leeson |
|---|---|
| Model | SPEEDMASTER |
| Category | Controller |
| Language | English |
LEESON Electric Corporation warrants products free from defects for one year from shipment.
Excludes all other warranties and disclaims responsibility for injury or damage caused by product misuse.
Limits LEESON Electric's liability for consequential damages and expenses.
Instructions for mounting the control unit using provided slots and hardware.
Guidelines for sizing and routing wires for armature, line current, and control signals.
Information on required fuses for AC line 1 and optional fuse for AC line 2 for protection.
Details on trimpot adjustments (MIN, MAX, I.R. COMP, CUR LIM, ACCEL) and their preset values.
Describes using two 10K speed potentiometers for two-speed control.
Explains using a DPDT switch to inhibit control and connect a dynamic brake resistor.
Improves speed regulation to ±1/2% of base speed using tachometer input.
Allows control output to follow tachometer voltage.
Using an SPST switch in series with Speedpot HI and Inhibit pin for stop/start.
Using a SPDT switch to connect Speedpot HI or Inhibit pin for motor stop/start.
In normal operation, no routine maintenance is needed. Clean cover with mild detergent.
To Next Page
