Leggett & Platt Performance Pro-motion Queen - User Manual

64 pages

Save Page as PDF

To Next Page

LPAdjustableBases.com

owners manual

PRO-MOTION

*Queen

*Split Cal-King

ENGLISH

SPANISH

FRENCH

Questions and Answers

S
Stephanie DiazAug 23, 2025
Why Leggett & Platt Performance Pro-motion Queen Indoor Furnishing head or foot section will elevate, but will not return to the horizontal (flat) position?
- S
  Sherry CunninghamAug 25, 2025
  If the head or foot section of your Leggett & Platt Indoor Furnishing elevates but won't return to the flat position, consider these potential causes and solutions: * The base mechanism might be obstructed. Elevate the base and carefully inspect for any obstructions, then remove them. * The head section may be too close to the wall, restricting movement. * The headboard may be too close to the edge of the mattress. Ensure there's a 1.5” to 2” distance between the headboard brackets and the mattress. Adjust if needed.
C
Chloe WilliamsNov 8, 2025
What to do if Leggett & Platt Performance Pro-motion Queen remote control will not activate base?
- E
  Eric FisherNov 8, 2025
  If the Leggett & Platt Indoor Furnishing remote control isn't activating the base, here are a few things to check: * Ensure the power cord is properly plugged into a working, grounded electrical outlet. It's recommended to use a grounded surge protection device. * Test the outlet by plugging in another working appliance to see if it's functioning correctly. * Confirm the remote control is securely plugged into the motor. * Try resetting the electronic components by unplugging the power cord, waiting 30 seconds, and then plugging it back in. * Check the electrical service breaker box to make sure an electrical circuit breaker hasn't tripped. * A defective surge protection device or electrical outlet can also be the cause. Test the outlet by plugging in another working appliance...