LEGRAND Daker DK 4.5-6 kVA

Other manuals for LEGRAND Daker DK 4.5-6 kVA

Questions and Answers

T
Tyler RamseyAug 12, 2025
What to do if Er16 appears during the parallel installation test of LEGRAND UPS?
- J
  johncardenasAug 12, 2025
  If an Er16 error appears during the parallel installation test of the LEGRAND UPS, it means there's a parameter setting conflict between the UPS units. Repeat the process described in the “parameters check” and ensure that the common settings are the same for each unit. Process test 1.1 and check each parameter to ensure the settings are the same between each unit.
N
nancy65Aug 17, 2025
What to do if Er08 appears on LEGRAND Daker DK 4.5-6 kVA?
- S
  Stephanie BarnesAug 17, 2025
  An Er08 error on the LEGRAND UPS may appear due to a few reasons. First, the output voltage difference between units might be higher than 1.0Vac during parallel system startup. Check the inverter output voltage independently for each unit and calibrate units with abnormal output voltage. Second, there may be improper installation or a parallel system communication failure. In this case, check the parallel setting and repeat the Er-21 checks.
K
Kristina LaneAug 23, 2025
Why does Er17 appear on my LEGRAND Daker DK 4.5-6 kVA?
- J
  johnmillerAug 23, 2025
  The Er17 error on your LEGRAND UPS can occur for a couple of reasons. It could be that two or more units have the same ID number in a parallel system. Alternatively, the parallel function might not be enabled, but the ID number isn't set to 01 for a single unit. To resolve this, change the ID number setting, or set the ID number to 01 if using a single unit.
M
Megan PinedaAug 29, 2025
How to fix Er34 error on LEGRAND Daker DK 4.5-6 kVA UPS?
- J
  Julia Brown MDAug 29, 2025
  The Er34 error on a LEGRAND UPS indicates that new UPS version unit(s) are paralleled with older version unit(s). To resolve this, use the “UPS Setting Tool” software to enable special function flag #8. This makes the new version compatible with the old one.
D
Donna WaltersSep 5, 2025
What to do if LEGRAND Daker DK 4.5-6 kVA UPS shows Er27?
- J
  Jennifer DavidsonSep 5, 2025
  The Er27 error on the LEGRAND UPS means that the UPS is not working in “Normal Mode”. Since “ECO Mode” and “Frequency-Converter Mode” are not supported for parallel systems, change the UPS setting to “Normal mode”.