To Next PageTo Next Page
Need help?Do you have a question about the LEGRAND Plexo 55 and is the answer not in the manual?
Specifies the operating voltage and frequency for the receiver.
Indicates the operating radio frequency of the device.
Details the current draw of the receiver during operation.
Defines the acceptable ambient temperature limits for the receiver.
Specifies the maximum load capacity for the 489 70 model.
Specifies the maximum load capacity for the 489 72/73 models.
Lists the compatible remote control transmitters for the receiver.
Illustrates recommended distances for reliable remote control operation.
Provides a visual guide for the sequential installation process.
Shows electrical connections for model 489 70.
Shows electrical connections for model 489 72/73.
Indicates pressing a specific button and its indicator status.
Indicates pressing and holding a button for over 2 seconds.
Indicates releasing a button.
Defines the operating mode for timer functions.
Defines the operating mode for switch functions.
Defines the operating mode for pushbutton functions.
Procedure for teaching the switch mode.
Procedure for teaching an 'On' code.
Procedure for teaching an 'Off' code.
Procedure for teaching a single 'Off' code for multiple receivers.
Procedure for setting the time delay in timer mode.
Table of available time delay settings and their corresponding indicator flashes.
Procedure for teaching the 'On/Dim' code.
Procedure for teaching the 'On/Off' code.
Steps to clear stored codes from the receiver.
Warning about the loss of all codes for an output when cleared.
Describes local operation in switch mode.
Describes local operation in timer mode.
Describes local operation in pushbutton and dimmer modes.
Illustrates the wiring for a remote dimmer setup.
General