10
wide soundscape when played through 2 amps
simultaneously.
How to do this:
1. For the left stereo signal connect the output
socket A (5) to the input of amp 1.
2. Connect the output socket B (3) to the amp that
should render the right FX signal.
3. Connect the left stereo output from your effects
unit to the input socket A (2).
4. Connect the right stereo output from your
effects unit to the input socket A/B (1).
5. Use the left True-Bypass switch (9) to activate
both amplifiers.
6. Use the phase inverter switch (4) to find out
which setting you prefer.
7. Use the ground lift switch (6) to determine which
position eliminates the most background noise.
8. There you go!
Device connections
Output A (5) Amplifier 1 (left stereo signal)
Output B (3) Amplifier 2 (right stereo signal)
Input A (2) Left stereo signal from FX unit
Input A/B (1) Right stereo signal from FX unit
To Next Page
Loading...
