MANUAL LEKKER BIKES / Amsterdam+ 5 MANUAL LEKKER BIKES / Amsterdam+ 6
CHAPTER 1
1. Congratulations! You are the proud owner of a brand
new Amsterdam+. When you receive your bike, the first
thing to do is check that it has arrived in perfect
condition, Open the top of the box, and visually inspect
the bike.
2. Remove the bike from the box, be careful, as E-bikes
are generally much heavier than standard bikes, so
some help maybe needed for this step. Once removed,
you will find a small accessory box, the charger box and
of course your bike!
3. For the correct assembly of your bike you will need
the following tools; 8mm/10mm/15mm spanners,
3/4/5/6mm Allen keys, a small amount of lithium
grease and a pump.
Getting started
CHAPTER 2
Handlebar fitment and
adjustment
4. Remove all the packaging, cut the cable ties
holding the handlebars in place and proceed to
step 5.
5. The handlebars are already fitted to the
handlebar stem on your Amsterdam+. You would
only need to center and fasten them!
6. Now it’s time to adjust the angle of the brake
levers to your desired position. Using a 5mm Allen
key, loosen the two bolts on each of the brake
levers to allow you to move them, once in the
correct position tighten the bolts to the
manufacturer’s torque recommendation.
To Next Page
Loading...
