Why is my Lelit PS11N Iron not producing steam?
Your Lelit Iron might not be producing steam because the iron switch is off; press the iron switch and wait 4 minutes for the iron plate to warm up. Alternatively, the boiler switch might be off; press the boiler switch and wait 10 minutes for the boiler to produce steam. It could also be that there is no water in the tank; fill the tank carefully following the instructions.
What to do if Lelit PS11N releases steam mixed with water?
If your Lelit Iron releases steam mixed with water, it could be due to overfilling the tank. Empty the tank and release all the steam before opening the cap. Another possibility is that the iron plate is not hot enough. Ensure the temperature knob is set to the “cotton°°°” position.
Why does my ironing board get wet when using the Lelit PS11N?
If your ironing board gets wet when using the Lelit Iron, the cover might not be absorbent enough. Use a thicker cover, or two covers, to create a thicker surface to absorb the steam better. Also, it may be due to steam mixed with water leaking from the iron; refer to the instructions for addressing steam mixed with water.
How to clean dirty water coming from Lelit PS11N Iron?
If your Lelit Iron releases dirty water, it may be due to dirty water having entered the tank. Fill the empty tank with 1 liter of tap water, screw on the cap, shake the machine, open the cap, and empty the tank. Repeat this until the water is clean. Before ironing again, release some steam onto a cloth until clean steam comes out. Avoid using any additives.
Why I don't get much steam from Lelit Iron boiler?
If you aren’t getting much steam from the Lelit Iron boiler, it’s possible that water spilled over the cap while filling the tank and wet the insulating material. Use the machine as usual to dry the insulating material with the machine's heat. If the problem persists after one hour of use, contact the service center.
Safety cap for the boiler tank.
Switch to turn the iron on or off.
Switch to activate the boiler.
Button to activate steam release.
Knob for adjusting iron plate temperature.
Important safety warnings during operation and after use.
Recommendations for water type and cleaning.
What to do if you don't get much steam from the boiler.
Troubleshooting steam from the iron mixed with water.
Solutions when the iron does not produce any steam.
Addressing issues where the ironing board gets wet.
Steps to resolve the iron releasing dirty water.
To Next Page
General
