Why does my Lelit PS21 Iron leak steam mixed with water?
If your Lelit Iron is leaking steam mixed with water, it might be due to overfilling the tank. The issue should resolve itself as the excess water empties. Keep the steam button pressed until the water level is correct. Also, ensure the iron plate is sufficiently hot before using steam by setting the temperature knob to “cotton°°°)”.
What to do if my Lelit PS21 Iron does not give off steam?
If your Lelit Iron isn't producing steam, ensure the iron button is on, indicated by the red LED. Allow 4 minutes for the iron plate to warm up. Also, check that the boiler button is activated (red LED on) and wait 10 minutes for steam production. Finally, verify the water level and refill if the low water indicator is on, following the instructions carefully.
How to fix steam going out from the boiler of Lelit Iron?
If steam is escaping from the boiler of your Lelit Iron, it's possible that water spilled over the cap during refilling and wet the insulation. To fix this, use the machine normally to dry the insulation with its heat. If the problem persists after an hour of use, contact a service shop.
Essential safety warnings and precautions for operating the appliance, ensuring user protection.
Step-by-step instructions for proper setup and operation of the steam ironing machine.
Key recommendations and tips for optimal performance and maintenance.
Detailed technical specifications including power, pressure, and capacity of the appliance.
Guide to identifying and resolving common problems encountered during operation.
Instructions for the correct and environmentally responsible disposal of the product at its end-of-life.
Official statement confirming the product's compliance with relevant European directives and standards.
Overview of the legal warranty applicable to the product based on the country of sale.
To Next Page
General
