Should the cutter bar hit an obstacle during mowing, it can
move backward thanks to the extension of the breakback
device (fig. 11).
- After extension of the breakback device: drive backwards a
few meters until the breakback device has locked back into
position.
6 DISMOUNTING FROM THE TRACTOR
- Lower the cutter bar.
- Switch off the tractor engine. Disengage the PTO shaft
from the tractor PTO.
- Place the PTO shaft in the hook (fig. 12).
- Set the parking jack in the lowest position.
- Lower the 3-point hitch until the parking jack is supported
by the ground.
- Depressurize the hydraulic system and disconnect the
hydraulic hose. Slide the dust cap onto the plug.
- Remove the control cord for the locking hooks from the
tractor cab.
- Disengage the top link from the machine.
- Uncouple the lower arms from the machine.
34
11
12
To Next Page
Loading...
